LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Tahoe Commercial, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Diagnostic Information And Procedures (4 Of 5)) >> Diagnostic Information and Procedures >> DTC P1255 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

For an overview of the component/system, refer to: Fuel System Description

Component Description
K111 Fuel Pump Power Control Module The control module contains a microprocessor used to process input data to control outputs.
The control module communicates with the engine control module via serial data.

When the ignition is turned On, the ECM sends a 12 V signal to the control module K111 to enable the fuel pump. If the engine is not started, the control module K111 turns the fuel pump Off after 6 s.

scientia non olet · About LEMON Manuals