Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P02E0 - P02E5, P02E8, P02E9, P02EB, P122B, P122C, P1425, U0654 is not set.
- If the DTC is set
- Go to next step: If the DTC is not set
- Clear the DTCs.
- Ignition Off - For greater than 1 min
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P122D is not set.
- If the DTC sets
- Ignition/Vehicle - Off
- Verify the following conditions do not exist: Blade @ Q38 Throttle Body
- Binding or Sticking @ Open/Close - Position
- Closed @ Engine Off
- Coking/Debris/Dirty/Visible Damage
- Open/Close - Without spring pressure
- Water intrusion - Ice
WARNING:Turn OFF the ignition before inserting fingers into the throttle bore. Unexpected movement of the throttle blade could cause personal injury.
- If a condition exists - Repair or replace as necessary
- Go to next step: If the DTC does not set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Repeat step 2
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.