LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Tahoe Commercial, 4WD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Repair Instructions >> Rear Disc Brake Pad Wear Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Remove the tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel) , or Tire and Wheel Removal and Installation (Aluminum Wheel)
  3. GM5519563Courtesy of GENERAL MOTORS COMPANY

    Rear Brake Bleeder Valve Cap (1) - Remove

  4. Disconnect the electrical connector. (3)
  5. Rear Disc Brake Pad Wear Sensor (2) - Remove
scientia non olet · About LEMON Manuals