LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Tahoe Commercial, 4WD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Repair Instructions >> Rear Disc Brake Pad Wear Sensor Replacement >> Installation Procedure

Installation Procedure

  1. GM5519563Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Rear disc brake pad wear sensor heads are brittle and should be handled with care when installing.

    Rear Disc Brake Pad Wear Sensor (2) - Install

  2. Connect the electrical connector. (3)
  3. Rear Brake Bleeder Valve Cap (1) - Install
  4. Install the tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel) , or Tire and Wheel Removal and Installation (Aluminum Wheel)
  5. Remove the support and lower the vehicle.
  6. Reset the brake pad life monitor system. Brake Pad Life Monitoring Reset 
scientia non olet · About LEMON Manuals