Installation Procedure
Rear Brake Caliper Guide Pin Boot (1) - Install NEW [2x]
- Rear Brake Caliper Guide Pin (2) - Install [2x]
Rear Brake Caliper (1) - Install
- CAUTION:NOTE:
DO NOT use any air tools to remove or install the guide pin bolts. Use hand tools ONLY.
Rear Brake Caliper Guide Pin Bolt (1) - Install and tighten [2x] - Fastener Specifications
Electrical Connector (1) @Rear Parking Brake Actuator - Connect
- NOTE:
Rear disc brake pad wear sensor heads are brittle and should be handled with care when installing.
{If equipped} Rear Disc Brake Pad Wear Sensor (2) @Rear Disc Brake Pad - Install
- {If equipped} Rear Brake Bleeder Valve Cap (1) - Install
- Install the tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel) , or Tire and Wheel Removal and Installation (Aluminum Wheel)
- Remove the support and lower the vehicle.
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1/5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
- Calibrate the park brake. Park Brake Calibration
NOTE:
The upper brake caliper guide pin is equipped with a bushing and must be installed in the same position.