Removal Procedure
- Inspect the fluid level in the brake master cylinder reservoir.
- If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the midway point before proceeding.
- If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed before proceeding.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1/5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
- Remove the front tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel) , or Tire and Wheel Removal and Installation (Aluminum Wheel)
{If equipped} Disconnect the electrical connector. (1)
{If equipped} Front Disc Brake Pad Wear Sensor (1) - Remove and DISCARD
Front Brake Caliper Guide Pin Clip (1) - Remove [2x]
Front Disc Brake Pad Retaining Spring (1) - Remove and DISCARD
Front Brake Caliper Guide Pin (1) - Remove [2x]
- Inspect front brake caliper guide pins (1), if bent discard and replace pins.
Front Disc Brake Pad (1) - Remove [2x]
- Using an appropriate tool, carefully press the brake caliper pistons into the caliper bores until fully seated.
NOTE:
When pistons are pushed in, ensure all four piston dust boots are correctly seated and sitting below the piston (s) face. This will ensure the dust boots do not contact the adhesive on the back of the brake pad assembly.