Front Brake Shield Replacement (RWL & ZW7): Removal
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1/5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the front tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel) , or Tire and Wheel Removal and Installation (Aluminum Wheel)
Front Brake Hose Bracket Bolt (1) - Remove
{If equipped} Front Disc Brake Pad Wear Sensor (1) @Front Brake Caliper - Remove
{If equipped} Front Disc Brake Pad Wear Sensor Retainer (2) - Remove
- {If equipped} Position the front disc brake pad wear sensor wiring harness (1) out of the way.
Front Brake Caliper Bolt (1) - Remove [2x]
- CAUTION:
Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
Remove the brake caliper and support with heavy mechanics wire. (1)
Front Brake Rotor Bolt (1) - Remove
- Front Brake Rotor (2) - Remove
Front Wheel Speed Sensor Bolt (2) - Remove
- Front Wheel Speed Sensor Wiring Harness (1) - Remove
Front Wheel Hub Bolt (1) - Remove [4x]
Front Brake Bearing Shield (1) - Remove
Front Wheel Hub (3) - Remove
- Front Brake Shield (2) - Remove
- Front Wheel Hub Seal (1) - Remove and DISCARD [2x]