LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Tahoe Commercial, 4WD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Diagnostic Information and Procedures >> DTC C116B >> Circuit/System Testing

Circuit/System Testing

    NOTE:

    It may take up to 2 min for all vehicle systems to power down before an accurate ground or low reference circuit continuity test can be performed.

  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector: B172LR Rear Disc Brake Pad Wear Sensor - Left
  3. Test for less than 10 ohms between the test points: Ground circuit terminal 2 & Ground
    • If 10 ohms or greater 
    1. Test for less than 2 ohms between the test points: Ground circuit terminal 2@Component harness & The other end of the circuit
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Repair the open/high resistance in the ground connection.
    • Go to next step: If less than 10 ohms 
  4. Ignition - On/Vehicle - In Service Mode
  5. Verify the scan tool parameter: Rear Brake Pad Wear Sensors = Greater than 10.5 V
    • If not the specified state 
    1. Ignition/Vehicle - Off
    2. Disconnect the electrical connector: K160 Brake System Control Module
    3. Test for infinite resistance between the test points: Signal circuit terminal 1@Component harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component: K160 Brake System Control Module
    • Go to next step: If the specified state 
  6. Connect a 3 A fused jumper wire between the test points: Signal circuit terminal 1 & Ground circuit terminal 2
  7. Verify the scan tool parameter: Rear Brake Pad Wear Sensors = 0 V
    • If not the specified state 
    1. Ignition/Vehicle - Off & Remove - Jumper wire (s)
    2. Disconnect the electrical connector: K160 Brake System Control Module
    3. Ignition - On/Vehicle - In Service Mode
    4. Test for less than 1 V between the test points: Signal circuit terminal 1@Component harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • Go to next step: If less than 1 V
    5. Ignition/Vehicle - Off
    6. Test for less than 2 ohms between the test points: Signal circuit terminal 1@Component harness & Terminal X1 44@Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component: K160 Brake System Control Module
    • Go to next step: If the specified state 
  8. Test or replace the component: B172LR Rear Disc Brake Pad Wear Sensor - Left
scientia non olet · About LEMON Manuals