Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Pull upward from both sides of the rear side door sill garnish molding (1) to disengage retaining clips front to rear.
Rear Side Door Sill Garnish Molding (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Seat Track Front Outboard Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Seat Track Front Inboard Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Place the rear seat in the fold and tumble position.
Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Seat Adjuster Track Finish Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Seat Track Rear Inboard Cover-Inboard (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Seat Track Rear Inboard Cover-Outboard (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Bolt (1) - Remove [4x]
Disconnect the electrical connector.
Release the wiring harness retainer.
Return the rear seat to the original position.
Rear Seat (2) - Remove