Installation Procedure
Rear Seat (2) - Install
- Connect the electrical connector.
- Install the wiring harness retainer.
- Position the seat as necessary to access the seat bolts.
- Rear Seat Bolt (1) - Install and tighten in sequence [4x] - Fastener Specifications
Place the rear seat in the fold and tumble position.
- Rear Seat Track Rear Inboard Cover-Outboard (1) - Install
Rear Seat Track Rear Inboard Cover-Inboard (1) - Install
Rear Seat Adjuster Track Finish Cover (1) - Install
- Return the rear seat to the original position.
Rear Seat Track Front Inboard Cover (1) - Install
Rear Seat Track Front Outboard Cover (1) - Install
Rear Side Door Sill Garnish Molding (1) - Install
CAUTION:
Refer to Fastener Caution .
NOTE:
If the Proper torque sequence is not followed the seat may not operate smoothly.