Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Using a flat-bladed plastic trim tool, release the retaining clips.
Pull upward from both sides of the rear side door sill garnish molding (1) to disengage retaining clips front to rear.
Rear Side Door Sill Garnish Molding (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Seat Track Front Outboard Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Seat Track Front Inboard Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Place the rear seat in the fold and tumble position.
Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Seat Adjuster Track Finish Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Seat Track Rear Inboard Cover-Inboard (1) - Remove
Return the rear seat to the original position.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Position the seat as necessary to access the seat bolts.
Rear Seat Bolt (1) - Remove [4x]
Disconnect the electrical connector.
Rear Seat (2) - Remove