LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Tahoe Commercial, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Rear Seat Cushion Cover and Pad Removal and Installation (Bucket) >> Removal Procedure

Removal Procedure

  1. GM5599026Courtesy of GENERAL MOTORS COMPANY

    Reposition the seat as necessary.

  2. Rear Seat Recliner Handle Bolt Cap (1) - Remove
  3. Rear Seat Riser Bolt (2) - Remove
  4. Rear Seat Adjuster Handle (3) - Remove
  5. GM5599027Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Recliner Handle Bolt Cap (1) - Remove

  6. Rear Seat Riser Bolt (2) - Remove
  7. Rear Seat Recliner Handle (3) - Remove
  8. GM5599028Courtesy of GENERAL MOTORS COMPANY

    Front Seat Bolt (1) - Remove

  9. Using a suitable plastic trim tool, release the retaining tabs.
  10. Rear Seat Recliner Outer Finish Cover - Outboard (2) - Remove
  11. GM5599029Courtesy of GENERAL MOTORS COMPANY

    Front Seat Bolt (1) - Remove

  12. Using a suitable plastic trim tool, release the retaining tabs.
  13. Rear Seat Recliner Outer Finish Cover - Inboard (2) - Remove
  14. GM5605756Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Riser Finish Cover Retainer (1) - Remove [2x]

  15. Release the J-channel retainers from the rear seat cushion cover and rear seat cushion trim panel (2).
  16. Rear Seat Cushion Trim Panel (2) - Reposition
  17. GM5606266Courtesy of GENERAL MOTORS COMPANY

    Remove the retainers holding the rear seat cushion cover (1) from the rear seat cushion frame.

  18. Disconnect the electrical connectors and reposition the wiring harness as necessary.
  19. Remove the rear seat cushion cover and pad (1) as an assembly.
scientia non olet · About LEMON Manuals