Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Rear Seat Recliner Handle Bolt Cap (1) - Remove
Rear Seat Riser Bolt (2) - Remove
Rear Seat Adjuster Handle (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Recliner Handle Bolt Cap (1) - Remove
Rear Seat Riser Bolt (2) - Remove
Rear Seat Recliner Handle (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Seat Bolt (1) - Remove
Using a suitable plastic trim tool, release the retaining tabs.
Rear Seat Recliner Outer Finish Cover - Outboard (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Place the opposite rear seat in the fold and tumble position.
Front Seat Bolt (1) - Remove
Using a suitable plastic trim tool, release the retaining tabs.
Rear Seat Recliner Outer Finish Cover - Inboard (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Center Belt Anchor Plate Bolt (1) - Remove
Rear Seat Belt Buckle (2) - Reposition
Reposition the rear seat center belt and anchor plate (3) as needed.
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Riser Finish Cover Retainer (1) - Remove [2x]
Release the J-channel retainers from the rear seat cushion cover and rear seat cushion trim panel (2).
Rear Seat Cushion Trim Panel (2) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Remove the retainers holding the rear seat cushion cover (1) from the rear seat cushion frame.
Disconnect the electrical connectors and reposition the wiring harness as necessary.
Remove the rear seat cushion cover and pad (1) as an assembly.