Installation Procedure
Install the rear seat cushion cover and pad (1) as an assembly.
- Install the retainers holding the rear seat cushion cover to the rear seat cushion frame.
- Connect the electrical connectors and position the wiring harness.
Rear Seat Cushion Trim Panel (2) - Install
- Secure the J-channel retainers of the rear seat cushion cover and rear seat cushion trim panel (2).
- Rear Seat Riser Finish Cover Retainer (1) - Install [2x]
Position the rear seat center belt and anchor plate (3) to the original location.
- Rear Seat Belt Buckle (2) - Install
- Rear Seat Center Belt Anchor Plate Bolt (1) - Install and tighten - Fastener Specifications
Rear Seat Recliner Outer Finish Cover - Inboard (2) - Install
- Front Seat Bolt (1) - Install and tighten - Fastener Specifications
- Return the opposite rear seat to the original position.
Rear Seat Recliner Outer Finish Cover - Outboard (2) - Install
- Front Seat Bolt (1) - Install and tighten - Fastener Specifications
Rear Seat Recliner Handle (3) - Install
- Rear Seat Riser Bolt (2) - Install and tighten - Fastener Specifications
- Rear Seat Recliner Handle Bolt Cap (1) - Install
Rear Seat Adjuster Handle (3) - Install
- Rear Seat Riser Bolt (2) - Install and tighten - Fastener Specifications
- Rear Seat Recliner Handle Bolt Cap (1) - Install
CAUTION:
Refer to Fastener Caution .