LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Tahoe Commercial, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Rear Seat Cushion Cover and Pad Removal and Installation (40 Percent) >> Installation Procedure

Installation Procedure

  1. GM5606266Courtesy of GENERAL MOTORS COMPANY

    Install the rear seat cushion cover and pad (1) as an assembly.

  2. Install the retainers holding the rear seat cushion cover to the rear seat cushion frame.
  3. Connect the electrical connectors and position the wiring harness.
  4. GM5605756Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Cushion Trim Panel (2) - Install

  5. Secure the J-channel retainers of the rear seat cushion cover and rear seat cushion trim panel (2).
  6. Rear Seat Riser Finish Cover Retainer (1) - Install [2x]
  7. GM5608391Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Recliner Outer Finish Cover - Inboard (2) - Install

    8. CAUTION:

    Refer to Fastener Caution .

  8. Front Seat Bolt (1) - Install and tighten - Fastener Specifications 
  9. Return the opposite rear seat to the original position.
  10. GM5599028Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Recliner Outer Finish Cover - Outboard (2) - Install

  11. Front Seat Bolt (1) - Install and tighten - Fastener Specifications 
  12. GM5599027Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Recliner Handle (3) - Install

  13. Rear Seat Riser Bolt (2) - Install and tighten - Fastener Specifications 
  14. Rear Seat Recliner Handle Bolt Cap (1) - Install
  15. GM5599026Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Adjuster Handle (3) - Install

  16. Rear Seat Riser Bolt (2) - Install and tighten - Fastener Specifications 
  17. Rear Seat Recliner Handle Bolt Cap (1) - Install
scientia non olet · About LEMON Manuals