Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Reposition the seat as necessary.
Using a suitable plastic trim tool, release the two rear seat anchor plate bezel plastic retainers.
Rear Seat Anchor Plate Bezel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Place the rear seat armrest (2) in the full upright position.
Unzip the rear seat armrest cover and reposition as necessary to access the rear seat armrest bolt (1).
Rear Seat Armrest Bolt (1) - Remove
Rear Seat Armrest (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Unzip the left and right rear seat back cover zippers.
Reposition the rear seat back cover, pad, J-channel retainers, and retainers as necessary.
Using a suitable flat-bladed tool, open the rear seat head restraint cable cover (1).
Release the rear seat head restraint cable (2).
Courtesy of GENERAL MOTORS COMPANY

Raise the rear seat head restraint (3) to gain access to the rear seat head restraint guide bezels (1).
Twist the rear seat head restraint guide bezels (1) counter clockwise while lifting the bezels upward onto the head restraint adjuster rod.
Using a suitable pointed or flat bladed tool, push the rear seat head restraint guide clip (2) rearward while pulling upward on the rear seat head restraint (3).
Rear Seat Head Restraint (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Remove the rear seat back cover and pad (1) as an assembly.