Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Place the rear seat armrest in the full down position.
Rear Seat Back Opening Finish Cover Retainer (1) - Remove [2x]
Push down on the rear seat armrest mount panel (2) then pull outward and upward to release the retaining tabs.
Rear Seat Armrest Mount Panel (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Riser Bolt (1) - Remove [2x]
Rear Seat Armrest (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Center Belt Anchor Plate Bolt (1) - Remove
Rear Seat Belt Buckle (2) - Reposition
Reposition the rear seat center belt and anchor plate (3) as needed.
Courtesy of GENERAL MOTORS COMPANY

Using a suitable plastic trim tool, release the retaining tabs.
Slide the rear seat center belt through the rear seat center belt opening bezel (1).
Rear Seat Center Belt Opening Bezel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Reposition the rear seats as necessary.
Using a suitable plastic trim tool, release the two rear seat anchor plate bezel plastic retainers.
Rear Seat Anchor Plate Bezel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Unzip the left and right rear seat back cover zippers.
Reposition the rear seat back cover, pad, J-channel retainers, and retainers as necessary.
Using a suitable flat-bladed tool, open the rear seat head restraint cable cover (1).
Release the rear seat head restraint cable (2).
Courtesy of GENERAL MOTORS COMPANY

Twist the rear seat head restraint guide bezels (1) counter clockwise while lifting the bezels upward onto the head restraint adjuster rod.
Using a suitable pointed or flat bladed tool, push the rear seat head restraint guide clip (2) rearward while pulling upward on the rear seat head restraint (3).
Rear Seat Head Restraint (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Feed the rear seat center belt through the opening in the rear seat back cover and pad (1).
Remove the rear seat back cover and pad (1) as an assembly.