LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Tahoe Commercial, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Front Seat Center Armrest Hinge Finish Inner Cover Replacement (Seat Cushion) >> Installation Procedure

Installation Procedure

  1. GM5581809Courtesy of GENERAL MOTORS COMPANY

    Front Seat Center Armrest Hinge Finish Inner Cover (1) - Install

  2. GM5047494Courtesy of GENERAL MOTORS COMPANY

    Front Seat Cushion Center Pad (2) - Install

  3. If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps:
    1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
    2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers 
    4. Ensure there are no gaps in the thread locking adhesive once applied to the component.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Front Seat Cushion Center Pad Pivot Bolt (1) - Install and tighten - Fastener Specifications 
  5. GM5047488Courtesy of GENERAL MOTORS COMPANY

    Front Seat Center Armrest Hinge Finish Cover-Lower (1) - Install [2x]

  6. Front Seat Center Belt Anchor Plate - Install
  7. Front Seat Center Belt Buckle - Install
  8. GM5045528Courtesy of GENERAL MOTORS COMPANY

    Front Center Seat Armrest (2) - Install

  9. Front Seat Center Armrest Bolt (1) - Install and tighten [2x] - Fastener Specifications 
  10. Connect the latch release cable.
  11. GM5282281Courtesy of GENERAL MOTORS COMPANY

    Front Seat Armrest Adjust Retainer (3) - Install

  12. Front Seat Armrest Adjust Retainer Bolt (2) - Install and tighten - Fastener Specifications 
  13. If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps:
    1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
    2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers 
    4. Ensure there are no gaps in the thread locking adhesive once applied to the component.
  14. Front Seat Center Armrest Pivot Bolt (1) - Install and tighten - Fastener Specifications 
  15. GM5045533Courtesy of GENERAL MOTORS COMPANY

    Front Seat Center Armrest Hinge Finish Cover-Upper (1) - Install [2x]

  16. GM5027621Courtesy of GENERAL MOTORS COMPANY

    Front Center Seat (3) - Install - Front Center Seat Removal and Installation 

scientia non olet · About LEMON Manuals