Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connectors as necessary.
Front Seat Back Rear Center Cover (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Front Seat Center Armrest Hinge Finish Inner Cover (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Center Pad (2) - Install
If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps:
1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.

CAUTION:

Refer to Fastener Caution .

Front Seat Cushion Center Pad Pivot Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Center Seat Armrest (2) - Install
Front Seat Center Armrest Bolt (1) - Install and tighten [2x] - Fastener Specifications
Connect the latch release cable.
Courtesy of GENERAL MOTORS COMPANY

Front Seat Center Armrest Hinge Finish Cover-Lower (1) - Install [2x]
Front Seat Center Belt Anchor Plate - Install
Front Seat Center Belt Buckle - Install
Courtesy of GENERAL MOTORS COMPANY

Front Seat Armrest Adjust Retainer (3) - Install
Front Seat Armrest Adjust Retainer Bolt (2) - Install and tighten - Fastener Specifications
If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps:
1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.
Front Seat Center Armrest Pivot Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Seat Center Armrest Hinge Finish Cover-Upper (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Center Seat (3) - Install - Front Center Seat Removal and Installation