Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Disconnect the rear seat belt mini-latch (1).
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
3rd Row Seat Riser Cover (1) - Remove [3x]
3rd Row Seat Bolt - Front (2) - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of retainers may vary based on option content.

Rear Compartment Floor Stowage Compartment Divider Retainer (1) - Remove [2x]
Rear Compartment Floor Stowage Trim Compartment (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Lower the seat back to the folded position.
3rd Row Seat Bolt - Rear (1) - Remove [5x]
Disconnect the electrical connector.

NOTE:

If the seat back is raised to the up position, it will latch in that position. This could make any repair procedures more difficult.