LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Tahoe Commercial, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Bumpers And Fascias >> Repair Instructions >> Front Bumper Fascia Upper Stiffener Replacement >> Removal Procedure

Removal Procedure

  1. GM5537676Courtesy of GENERAL MOTORS COMPANY

    Front Bumper Fascia (2) - Remove - Front Bumper Fascia Removal and Installation (without Front Fascia Extension) , or Front Bumper Fascia Removal and Installation (with Front Fascia Extension) 

  2. GM5520779Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Headlamp Bolt- Left Side and Right Side (1) - Remove [6x]

  3. GM5520782Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Headlamp Bolt- Left Side and Right Side (1) - Remove [6x]

  4. GM5520784Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Release the front headlamp guide pin from the front bumper fascia guide (1).

  5. Front Headlamp- Left Side and Right Side (2) - Remove [2x]
  6. Release the wiring harness retaining tab.
  7. Disconnect all electrical connectors.
  8. GM5544167Courtesy of GENERAL MOTORS COMPANY

    Loosen the left and right side front bumper fascia upper stiffener nut (1).

  9. Remove the left and right side front bumper fascia upper stiffener bolt (2).
  10. GM5544169Courtesy of GENERAL MOTORS COMPANY

    Pull the front bumper fascia upper stiffener (1) up and out over the stud.

scientia non olet · About LEMON Manuals