Circuit/System Testing

Ignition OFF, disconnect the harness connector at the A23D Front Side Door Latch-Driver. Ignition ON
Test for greater than 4 V between the signal circuit terminal 2 and ground
- If 4 V or less
1. Test circuit 126 for a short to ground.
  - If a short to ground is found, repair the fault on the circuit.
  - Go to next step: If a short to ground is not found
2. Test circuit 126 for an open/high resistance.
  - If an open/high resistance is found, repair the fault on the circuit.
  - Go to next step: If an open/high resistance is not found.
3. Replace the K9 Body Control Module.
- Go to next step: If greater than 4 V
Test or replace the A23D Front Side Door Latch-Driver.