Installation Procedure
WARNING: This page is about a different variant/trim than selected.
If removed, inspect the reverse lockout assembly O-ring (3). Replace the reverse lockout assembly O-ring if necessary.
- Install the reverse lockout assembly (4) and bolt (1) and tighten to 18 N.m (13 lb ft).
- Install the reverse lockout solenoid (2).
Using the DT-49293 socket, install the Reverse Lockout Solenoid (2) and tighten the reverse lockout solenoid to 40 N.m (30 lb ft).
Connect the reverse lockout solenoid electrical connector (1).
- Lower the vehicle. Lifting and Jacking the Vehicle
CAUTION:
Refer to Fastener Caution .