Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Place the transmission in neutral.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
- Remove the propeller shaft (6). Refer to Two-Piece Propeller Shaft Replacement (Coupe with LGX and M13)Two-Piece Propeller Shaft Replacement (Coupe with LT1, LT4 and MJK, MM6)Two-Piece Propeller Shaft Replacement (Convertible with LGX and M13)Two-Piece Propeller Shaft Replacement (Convertible with LT1, LT4 and MJK, MM6)
Install the J 45012 holding fixture to the drive flange.
- While holding the J 45012 holding fixture, remove the flange nut using the J 29873 injector nozzle socket.
- Remove the J 45012 holding fixture.
Remove the drive flange thrust washer.
- Remove the drive flange using the J 45019 flange and pinion gauge remover.
Use the J 6125-1B slide hammer and J 23129 universal seal remover to remove the transmission case extension seal (1).