Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Lower Oil Pan, Drain Plug and Oil Filter (With Bolt Tightening Sequence)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant

Apply sealant (1) to the NEW lower oil pan. Adhesives, Fluids, Lubricants, and Sealers
Lower Oil Pan (2) - Install

CAUTION:

Refer to Fastener Caution .

Lower Oil Pan Bolt (3) - Install and tighten in sequence [11x] 10 N.m (89 lb in)
Fill the engine oil to the proper level with NEW engine oil.
- Approximate Fluid Capacities
- Adhesives, Fluids, Lubricants, and Sealers
Start the engine and inspect for leaks.