Inverter Lever Install
WARNING: This page is about a different variant/trim than selected.
Temporarily remove the clutch housing bolts (1).
Temporarily remove the clutch housing assembly (1).
Install the manual transmission selector lever (1).
Install the manual transmission selector lever pivot pin (1). Tighten to 41 N.m (30 lb ft). Adhesives, Fluids, Lubricants, and Sealers (M13)
Install the manual transmission shift lever retainer (1).
Apply a 1.7 mm (0.07 in) bead of RTV sealant (1) to the clutch housing. Adhesives, Fluids, Lubricants, and Sealers (M13)
Install the clutch housing assembly (1)
Install the clutch housing bolts (1). Tighten to 33 N.m (24 lb ft).