LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Camaro SS, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls And Fuel - 3.6L - Diagnostic Information And Procedures (1 Of 2)) >> Diagnostic Information and Procedures (1 Of 2) >> DTC P0351-P0356, P2300, P2301, P2303, P2304, P2306, P2307, P2309, P2310, P2312, P2313, P2315, or P2316 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    Circuit/System Testing must be performed before proceeding with Component Testing.

  1. Ignition/Vehicle - Off
  2. Remove the appropriate component: T8 Ignition Coil - Leave the electrical connector connected.
  3. Install the special tool: J-26792 Ignition Spark Tester
  4. Engine - Running
    5. NOTE:

    An erratic or weak spark is considered a no spark condition.

  5. Verify there is spark at the tool.
    • If there is no spark 

      Replace the component: T8 Ignition Coil

    • Go to next step: If there is spark 
  6. All OK.
scientia non olet · About LEMON Manuals