LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Camaro SS, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls And Fuel - 3.6L - Diagnostic Information And Procedures (1 Of 2)) >> Diagnostic Information and Procedures (1 Of 2) >> DTC P026B, P05EC, P0601-P0607, P060A-P060D, P0610, P061C, P062B, P062F, P0630, P064D-P064F, P06D1, P08FF, P134C, P160A, P160D, P160E, P161C, P16E9-P16F0, P16F3, P2610, P262B, P264F, P27B5, P30D6-P30DD, P3186, or P3191 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC P0602, P0630, P064F, P160A, P160D, P160E, P161C, P264F is not set.
    • If the DTC is set 
    1. Perform all necessary programming and setup procedures for the control module: K20 Engine Control Module
    2. Verify the DTC does not set.
      • If the DTC sets - Replace the component: K20 Engine Control Module
      • Go to next step: If the DTC does not set
    3. All OK.
    • Go to next step: If the DTC is not set 
  3. Verify DTC P026B, P05EC, P0605, P0607, P060A, P060B, P060C, P060D, P0610, P061C, P064D, P064E, P06D1, P134C, P2610, P27B5, P3191 is not set.
    • If the DTC is set 

      Replace the component: K20 Engine Control Module

    • Go to next step: If the DTC is not set 
  4. Verify DTC P0685 - P0690, P1682, P16A7, P16AF, P16B3, P16BC, P16BD, P16BF is not set.
    • Go to next step: If the DTC is not set 
  5. Verify DTC P0601, P0603, P0604, P0606, P062B, P062F, P08FF, P16F3, P16E9-P16F0, P262B, P30D6-P30DD is not set.
    • If the DTC is set 
    1. Ignition - On/Vehicle - In Service Mode
    2. Verify the scan tool parameter: Battery Voltage = The value should not spike or drop out.

      Perform the action while monitoring the parameter:

      • Wiggle the harness and connector(s) : K20 Engine Control Module
      • Wiggle the harness and connector(s) : X50A Fuse Block - Underhood
      • If the value spikes or drops out - Repair as necessary - B+ circuitorGround
      • If the value does not spike or drop out - Replace the component: K20 Engine Control Module
    • Go to next step: If the DTC is not set 
  6. All OK.