Automatic Transmission Case Hole Plug Installation

Courtesy of GENERAL MOTORS COMPANY

1. Prepare the automatic transmission case hole plug (1) for installation as follows:
   1. Remove all traces of the adhesive patch from the plug and the mating threads using the appropriate tools.
   2. Clean the threads of the plug and mating threads with denatured alcohol or equivalent and allow to dry.
   3. Apply thread locking adhesive to the plug. Adhesives, Fluids, Lubricants, and Sealers
   4. Ensure there are no gaps in the thread locking adhesive once applied to the plug.
CAUTION:

Refer to Component Fastener Tightening Caution .

2. Automatic Transmission Case Hole Plug (1) - Install and tighten [2x] - Fastener Specifications