Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P228A
- Engine = Running
- Fuel Rail Pressure is being controlled by Fuel Pressure Regulator 1 & 3.
- Ignition and Start Signal = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
P228B
- Engine = Running
- Fuel Rail Pressure is being controlled by Fuel Pressure Regulator 2.
- Ignition and Start Signal = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met