Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
For an overview of the component/system, refer to: Fuel System Description
| Circuit | Description |
|---|---|
| 12V Reference | Regulated voltage supplied by the control module. |
| Signal | The control module input circuit has an internal resistance connected to 5 V. |
| Low Reference | Grounded through the control module. |
| Component | Description |
|---|---|
| E11A Fuel Heater/Water in Fuel Sensor | The electrical fuel heater is integrated into the fuel filter.The sensor uses two electrodes to measure the electric conductivity of the fluid in the fuel filter assembly. Since water has a higher conductivity than diesel fuel, it can be determined how much water is in the filter. |
| K20 Engine Control Module | The control module contains a microprocessor used to process input data to control outputs. The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly. |