Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, verify that no other DTCs are set.
- If any other DTCs are set
- Go to next step: If no other DTCs are set
- Verify that DTC P220A, P220B, or P23B6 is not set
- If the DTC is set
Refer to Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC is set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.