Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P2006
- DTC P10C1, P10EC, P10ED, P2008, P2010, P2016, P2017, P201B, U064F = Not set
- DTC P20F8 is set.
- Intake Manifold Runner Control Valve Command = 0% - Greater than 2 s
Frequency the DTC runs = Continuously - After the running conditions are met
P20F8
- DTC P0071 - P0074, P0116 - P0119, P10C1, P10EC, P10ED, P2008, P2010, P2016, P2017, P201B, U064F = Not set
- Ambient Air Temperature = Warmer than -19°C (-2°F)
- Engine Coolant TemperatureWarmer than 30°C (86°F)
- Engine Cranking
- Ignition Voltage = Greater than 11 V
- Intake Manifold Runner Control Valve Command = Greater than 0%
- Intake Manifold Runner Control Valve Command = Stable - Greater than 1 s
Frequency the DTC runs = Continuously - After the running conditions are met
P295A
- DTC P0071 - P0074, P0116 - P0119, P10C1, P10EC, P10ED, P2008, P2010, P2016, P2017, P201B, U064F = Not set
- Ambient Air Temperature = Warmer than -19°C (-2°F)
- Engine Coolant TemperatureColder than 30°C (86°F)
- Engine Cranking
- Ignition Voltage = Greater than 11 V
- Intake Manifold Runner Control Valve Command = Greater than 0%
- Intake Manifold Runner Control Valve Command = Stable - Greater than 1 s
Frequency the DTC runs = Continuously - After the running conditions are met