Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P143C, P20C2, P221E
- DTC P10C6, P10DA, P10DB, P10DC, P10DD, P10F4, P20FF, U2412, U2626 = Not set
- DTCs related to the following system/component = Not Set
- B214 Reductant Temperature Sensor
- Reductant Heater
- Reductant Heater 2
- No other DTCs related to the concerned component are set.
- Ignition On or Engine Running
- Ignition and Start Switch Signal = Greater than 11 V
- Reductant Heater 3 = On
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 12 s
P20C1, P20C3, P20C4, P221F
- DTC P10F4, P20FF = Not set
- Ignition On or Engine Running
- Ignition and Start Switch Signal = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 4 s