Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify there are no DTCs set related to the following component/system:
- B9 Ambient Air Temperature Sensor
- B17 Barometric Pressure Sensor
- B26 Crankshaft Position Sensor
- B34 Engine Coolant Temperature Sensor
- B47B Fuel Rail Pressure Sensor
- B66 Intake Air Temperature Sensor
- B74 Manifold Absolute Pressure Sensor
- B75C Multifunction Intake Air Sensor
- B106 Throttle Position Sensor
- B115 Vehicle Speed Sensor
- M103 Turbocharger Vane Position Actuator
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Verify the scan tool parameter: Exhaust Gas Temperature Sensor = -39 to 899°C (-38 to 1, 650°F)
- If not between -39 and 899°C (-38 and 1, 650°F)
Refer to: Circuit/System Testing
- Go to next step: If between -39 and 899°C (-38 and 1, 650°F)
- If not between -39 and 899°C (-38 and 1, 650°F)
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.