Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the electrical connector: A38 Reductant Pump and Sensor Assembly
- Test for 1 to 6 ohms between the test points: Control terminal 9 & Control terminal 11
- If not between 1 and 6 ohms
Replace the component: A38 Reductant Pump and Sensor Assembly
- Go to next step: If between 1 and 6 ohms
- If not between 1 and 6 ohms
- Test for infinite resistance between the test points: Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component: A38 Reductant Pump and Sensor Assembly
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.