Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC U18A2 is not set.
- If the DTC is set
- Go to next step: If the DTC is not set
- Verify the scan tool parameter:
- Fuel Pump Motor Control Circuit High Test Status = Not Run or Okay
- Fuel Pump Motor Control Circuit Low Test Status = Not Run or Okay
- Fuel Pump Motor Control Circuit Open Test Status = Not Run or Okay
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.