Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P06AF is not set.
- If DTC P06AF is set
Replace the component: K71 Transmission Control Module
- Go to next step: If DTC P06AF is not set
- If DTC P06AF is set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Replace the component: K71 Transmission Control Module
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.