Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P02E0
Control Circuit = The control module detects an open circuit. - For greater than 1 s
P02E3
Control Circuit = Greater than 9 A - For greater than 3 s
P02EB
Control Circuit = Greater than 5.5 A - For greater than 1 s
P122B
Control CircuitSystem Voltage Out of Range = Less than 6 V - For greater than 1 s
P122C
Control Circuit = The control module detects a short circuit in the wiring harness. - For greater than 1 s
P1425
Control Circuit = Component or System Overtemperature - For greater than 1 s
P2957
Intake Air Flow Valve Position Desired Intake Air Flow Valve PositionGreater than 10% - For greater than 8 s