Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0181
- DTC P0182, P0183, P1103, P262B = Not set
- Engine = Running
- Engine Off Time = Greater than 8 h
- Engine Run Time = Less than 3 s
- Ignition and Start Signal = Greater than 8 V
- ECT Sensor = Warmer than -40°C (-40°F)
Frequency the DTC runs = Once - Per drive cycle - After the running conditions are met
P0182, P0183
- DTC P1103 = Not set
- Fuel Pump Driver Control Module Voltage Signal = Greater than 8 V
- Ignition and Start Switch Signal = On or Engine = Running
- Ignition and Start Signal = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
P0184
- DTC P0182, P0183 = Not set
- Fuel Pump Driver Control Module Voltage Signal = Greater than 8 V
- Ignition and Start Switch Signal = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met