Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0102, P0103
- Engine = Running - For greater than 1 s
- Engine Speed = Greater than 590 RPM
- Ignition and Start Signal = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 1 s
U060F, U1319
- DTC P14B6, U060F, U1346, U2011 = Not set
- DTC P14B6, U060F, U1346, U2011 = Not pending
- Ignition and Start Signal = Greater than 11 V
- Ignition Power Relay = On
- LIN Bus = Enabled
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 5 s