Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P0097, P0098, P00EA, P00EB, P0112, P0113, P0117, P0118, P1682, P16A7, P16BC, P2199, P2610 is not set.
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Verify the scan tool Freeze Frame/Failure Records parameters listed below are within 25°C (45°F) of the following parameter: Start-Up Engine Coolant Temperature Sensor
- Start-Up Intake Air Temperature Sensor
- Start-Up Intake Air Temperature Sensor 2
- Start-Up Intake Air Temperature Sensor 3
- If not within 25°C (45°F) of each other
- {Start-Up Intake Air Temperature Sensor} & {Start-Up Intake Air Temperature Sensor 2}
Replace the component: B75 Mass Airflow Sensor
- {Start-Up Intake Air Temperature Sensor 3} Refer to: DTC P00EA-P00EC
- Go to next step: If within 25°C (45°F) of each other
- Engine - Idling
- Verify the scan tool parameter: = -39 to 149°C (-38 to 300°F) and changes
- Intake Air Temperature Sensor
- Intake Air Temperature Sensor 2
- Intake Air Temperature Sensor 3
- If not in the specified range or does not change
- {Intake Air Temperature Sensor } Refer to: DTC P0097-P0099, P00F4-P00F6, or P0112-P0114
- {Intake Air Temperature Sensor 2} Refer to: DTC P0097-P0099, P00F4-P00F6, or P0112-P0114
- {Intake Air Temperature Sensor 3} Refer to: DTC P00EA-P00EC
- Go to next step: If in the specified range and changes
- Verify the appropriate scan tool parameter:
- Intake Air Temperature Sensor = The value should not spike or drop out.
- Intake Air Temperature Sensor 2 = The value should not spike or drop out.
- Intake Air Temperature Sensor 3 = The value should not spike or drop out.
Perform the action while monitoring the parameter:
- Wiggle the harness and connector: B65 Intake Manifold Pressure and Air Temperature Sensor
- Wiggle the harness and connector: B75 Mass Airflow Sensor
- Wiggle the harness and connector: K20 Engine Control Module
- If the value spikes or drops out
Repair as necessary - Wiring/Terminal(s)/Electrical Connector(s)
- Go to next step: If the value does not spike or drop out
- All OK.