Repair Instructions
WARNING: This page is about a different variant/trim than selected.
Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification
- Variable Geometry Turbocharger Actuator Replacement - M103 Turbocharger Vane Position Actuator
- For control module replacement, programming, and setup refer to: CONTROL MODULE REFERENCE
Additional Procedures
- Barometric Pressure Sensor Reset - Perform only when the following component/system is replaced or serviced: K20 Engine Control Module
- Turbocharger/Supercharger Boost Control Initial Position Learn
- Perform only when the following component/system is replaced or serviced:
- K20 Engine Control Module - Programmed /Replaced
- Turbocharger - Cleaned/Replaced