LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Repair Instructions (1 Of 2)) >> Repair Instructions >> Intake Air Pressure and Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5150211Courtesy of GENERAL MOTORS COMPANY

    Air Cleaner Outlet Duct Clamp (1) - Loosen [2x]

  2. Air Cleaner Outlet Front Duct (2) - Remove
  3. Plenum Front Panel Outer Reinforcement (1) - Remove - Plenum Front Panel Outer Reinforcement Removal and Installation
  4. GM5150241Courtesy of GENERAL MOTORS COMPANY

    Air Cleaner Outlet Duct Clamp (1) - Loosen

  5. Air Cleaner Outlet Duct (2) - Remove
  6. GM5613883Courtesy of GENERAL MOTORS COMPANY

    Disconnect the intake air pressure and temperature sensor electrical connector.

  7. Intake Air Pressure and Temperature Sensor Bolt (1) - Remove
  8. Intake Air Pressure and Temperature Sensor (2) - Remove
scientia non olet · About LEMON Manuals