LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Repair Instructions (1 Of 2)) >> Repair Instructions >> Fuel Pump Power Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5577762Courtesy of GENERAL MOTORS COMPANY

    Fuel Pump Power Control Module (2) @Fuel Pump Power Control Module Bracket (3) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Fuel Pump Power Control Module Nut (1) - Install and tighten [2x] - Fastener Specifications
  3. GM5808254Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Slide the fuel pump power control module bracket down and into the groves in the frame to install.

    Fuel Pump Power Control Module Bracket (4) - Install

  4. Fuel Pump Power Control Module Bracket Bolt (3) - Tighten [2x] - Fastener Specifications
  5. Engage the wiring harness retainer (2).
  6. Connect the fuel pump power control module electrical connector (1).
  7. Lower the vehicle.
  8. Perform the fuel pump power control module configuration. K111 Fuel Pump Power Control Module Configuration 
scientia non olet · About LEMON Manuals