Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Drain the cooling system. Cooling System Draining and Filling (GE 47716 L84, L87)Cooling System Draining and Filling (Static L84, L87)Cooling System Draining and Filling (Static LM2)Cooling System Draining and Filling (GE 47716 LM2)
Courtesy of GENERAL MOTORS COMPANY

Plenum Front Panel Outer Reinforcement (1) - Remove - Plenum Front Panel Outer Reinforcement Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

Remove the exhaust gas recirculation valve bracket nut (1) and reposition harness and retainers as needed.
Remove the heater inlet hose bracket (2) attached to the exhaust gas recirculation valve.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Only need to remove the 1 nut at the turbocharger stud.

Engine Wiring Harness Bracket Nut (2) - Remove
Engine Wiring Harness (1) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Exhaust Pressure Differential Sensor Bracket Stud (1) - Remove [2x]
Exhaust Pressure Differential Sensor Bracket (2) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Exhaust Pressure Sensor Hose Clamp (1) @Exhaust Pressure Differential Sensor Pipe - Disengage - Hose Clamp Replacement Guidelines - Spring Type
Courtesy of GENERAL MOTORS COMPANY

Exhaust Gas Recirculation Pipe Nut (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The clamp is part of the pipe and single use.

Exhaust Gas Recirculation Pipe Nut (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Exhaust Gas Recirculation Valve Hose (1) - Remove
Exhaust Gas Recirculation Outlet Pipe Gasket (2) - Remove and DISCARD
Exhaust Gas Recirculation Valve Vacuum Hose Clamp (3) - Remove and DISCARD