Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (2) - Install
Retainer (3) - Install
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (2) - Connect - Plastic Collar Quick Connect Fitting Service
Electrical Connector (1) - Connect
Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Tank Protector (2) - Install
Retainer (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Number of retainers may vary.

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @Retainer (2) - Install [4x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Number of retainers may vary.

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @Retainer (2) - Install [5x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Number of retainers may vary.

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @Retainer (2) - Install [3x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Wheelhouse Liner-Right Side (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

CAUTION:
Refer to Fastener Caution .

Front Wheelhouse Liner Bolt-Right Side (1) - Install and tighten [3x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Wheelhouse Liner Bolt-Right Side (1) - Install and tighten [3x] - Fastener Specifications
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) - Connect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe Insulator (1) - Install