Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Crankshaft Position Sensor (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Crankshaft Position Sensor Bolt (1) - Install and tighten - Fastener Specifications
Connect the crankshaft position sensor electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Starter Heat Shield (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Components removed for graphic clarity.

Engage the starter heat shield (2) into the retainer (1).
Starter Heat Shield Bolt (3) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Chassis Wiring Harness Front Bracket (4) - Install
Install the positive battery cable retainers to the chassis wiring harness front bracket.
Chassis Wiring Harness Front Bracket Front Bolt (3) - Install and tighten - Fastener Specifications
Chassis Wiring Harness Front Bracket Retainer (2) - Install [2x]
Chassis Wiring Harness Front Bracket Rear Bolt (1) - Install and tighten - Fastener Specifications
Front Wheelhouse Liner-Right Side - Install - Front Wheelhouse Liner Replacement
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1, 5W4)Battery Negative Cable Disconnection and Connection (KL9)
Perform the crankshaft position variation learn. Crankshaft Position Variation Learn