LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 3.0L (Lm2) Diesel - Repair Instructions (11 Of 11)) >> Repair Instructions >> Engine Mounting to Stand >> Special Tools

Special Tools

WARNING: This page is about a different variant/trim than selected.

EN-52449  Engine Stand Adapter

Equivalent regional tools: Special Tools

  1. Engine - Remove - Engine Removal and Installation (4WD, with RC1, without F47) , or Engine Removal and Installation (2WD, with RC1, without F47) , or Engine Removal and Installation (4WD, with RC1, with F47) , or Engine Removal and Installation (2WD, with RC1, with F47) , or Engine Removal and Installation (4WD, with WTX, with F47) , or Engine Removal and Installation (2WD, with WTX, with F47) , or Engine Removal and Installation (4WD, with WTX, without F47)Engine Removal and Installation (2WD, with WTX, without F47) 
  2. GM5207474Courtesy of GENERAL MOTORS COMPANY

    EN-52449  Engine Stand Adapter (2) @Engine Block (1) - Install

  3. Install the engine to a suitable engine stand. (1)
  4. Using a suitable lifting device, remove the engine from the stand.
  5. GM5207474Courtesy of GENERAL MOTORS COMPANY

    EN-52449  Engine Stand Adapter (2) @Engine Block (1) - Remove

  6. Engine - Install - Engine Removal and Installation (4WD, with RC1, without F47) , or Engine Removal and Installation (2WD, with RC1, without F47) , or Engine Removal and Installation (4WD, with RC1, with F47) , or Engine Removal and Installation (2WD, with RC1, with F47) , or Engine Removal and Installation (4WD, with WTX, with F47) , or Engine Removal and Installation (2WD, with WTX, with F47) , or Engine Removal and Installation (4WD, with WTX, without F47)Engine Removal and Installation (2WD, with WTX, without F47) 
scientia non olet · About LEMON Manuals