Cleaning and Inspection Procedure - Conditional

WARNING: This page is about a different variant/trim than selected.

NOTE:

The following cleaning and inspection and/or overhaul steps are ONLY to be performed as determined necessary based on the condition of the part being removed with the intention of reinstallation. The labor time to perform any of these steps is not included in the base labor time and if required would need to be documented and submitted as Other Labor Hours for warranty claim reimbursement. A description of the repairs performed must be documented in the technician correction comments.

Courtesy of GENERAL MOTORS COMPANY

Clean the camshaft components in solvent.

WARNING:

Refer to Safety Glasses and Compressed Air Warning

Dry the components with compressed air.
Inspect the camshaft bearing journals (1) and camshaft lobes (3) for following conditions:
1. Excessive scoring or pitting
2. Discoloration from overheating
3. Deformation from excessive wear, especially the camshaft lobes (3)
Inspect the hexagon (2) for damage.
Inspect the threaded hole (4) for damage.
Inspect the corresponding valve rocker arms for damage.
If any of the conditions above exist on the camshafts, replace the camshafts.
Courtesy of GENERAL MOTORS COMPANY

Inspect the cylinder head (1) for the following:
1. Cracks, damage, or pitting in the combustion chambers.
2. Debris in the oil galleries, continue to clean the galleries until all debris is removed.
3. Coolant leaks or damage to the deck face sealing surface, if coolant leaks are present, measure the surface warpage as described under cylinder head measurement deck flatness inspection.
4. Damage to any gasket surfaces.
5. Burnt or eroded areas in the combustion chamber.
6. Cracks in the exhaust ports (3) and combustion chambers.
7. External cracks in the water passages.
8. Restrictions in the intake or exhaust ports (3).
9. Restrictions in the cooling system passages.
10. Rusted, damaged or leaking core plugs.
Inspect the exterior of the camshaft housing ladder frame (2) for the following conditions:
1. Damage to the camshaft housing ladder frame (4) bolt holes.
2. Damage to the injector bore holes.
3. Damage to the oil passages.
Inspect the interior of the camshaft housing ladder frame (2) for the following conditions:
1. Inspect the camshaft housing ladder frame (2), casting imperfections, cracks or damage.
2. Inspect the camshaft housing ladder frame (2) seal locations (1) for cracks or damage.
If the cylinder head (1) or ladder frame (2) is cracked or damaged, they must be replaced. No welding or patching of the is allowed.